Dividers for Vinyl Records, CDs, books
do you have any question？
Item details
Handmade
Materials: PLA
For those of you with more records than you know what to do with, you probably organise them by genre, or by year. Maybe a bit of both. (Maybe autobiographically...)
Well, whatever your choice, now you can support your organisational flare with these bright, bold and beautiful dividers. You choose the wording (there's probably a limit to the number of letters but try me and I'll let you know if there're any problems. I think the longest I've done so far is East/South African Jazz), so whether you want something common like <Rock> or something more specific like Dad rock, '86-'89 you can be your own collector and do what suits you and your tastes best.
You can have whatever colour you want as well (as long as it's one I offer) so do them all the same or each one different. Again, it's up to you.
The writing runs in the same direction on all of them. Obviously it's cut through, so only readable from one side, but if you want them to be readable from the other side you just turn them over and the writing will either read top to bottom or bottom to top. You could even place them flat on the shelf if you wanted to and have the records sitting on top. I use all capitals because lower case letters are too hard to print right with any consistency.
WARNING: these are 3d printed and there will be some surface texture on one side. Don't just shove them between your records or you may damage the sleeves. It's not so rough that it's going to imprint once it's in there, but it will scratch on the way in if you're not careful. Just open up a gap, slot it in, then close the gap again. Done.
The dividers are 8cm deep by 12.5cm tall, with the bit with the lettering being about 2.5cm wide. They're 1mm thin, so they don't take up a load of space on your shelf. (The bit that goes between the records is about 10cm of that 12.5cm.) There's a 2mm tall ridge that runs along the divider to stop it from disappearing between your records, but if your records are quite loose then you'll need to just be aware that the bit that goes between the records doesn't run a full 12" so isn't going to be pressed up against the back of the shelf. I hope that makes sense.
PROCESSING
It normally takes 4-5 business days to process your order. Please note that holidays & weekends are not included.
Orders involving personalization that includes logos, signatures, or graphics that need to be digitized require additional time.
SHIPPING
Shipment takes approximately 7 to 12 business days to reach destination countries.
Please note: Total Delivery Time = Processing Time + Shipping Time
Attention: More or less time may needed for different items.
Please wait patiently, order as soon as possible, delivery in time.
Eligible for return:
Wrong or damaged item.
Return within 10 days after delivery date.
Refund & Exchange issued within 5 business days.
Non-Returnable Items
1. Items outside the 10 days warranty time-frame.
2. Washed, worn, used or misused items.
3. Customer's error personalization information.
50% partial refund: Customer's address is not detailed, leading to the items be returned to us.
30% partial refund: The items has been delivered to its place, the customer did not receive it. Please contact the local post office . If still no result.
